¶ Factory reset Cordless Yealink Desk Phones
Factory resetting a Yealink phone is a simple procedure:
- Locate the OK key on the phones base.
- Press and hold the OK key until you see a prompt on the screen.
- Press the OK soft key (below the screen) to confirm the reboot.
- Wait for the reboot to complete.
- Your phone may update its configuration after the reboot which may result in a second reboot process automatically within a minute or two of the first reboot.
¶ Factory reset a Yealink W52P / W56P / W60P / W70B
¶ Applicable to Yealink W52P/H, W56P/H, W60P, W70B
Follow the steps below to factory reset your Yealink W52P/H, W56P/H, W60P, W70B device in order to bring back the factory default settings. This must be done before provisioning your Yealink W52P/H, W56P/H, W60P, W70B in case the device has residual settings of a previous configuration.
¶ Reset Yealink Base Station to Factory Defaults: W52P, W56P, W60P, W70B
- Turn off the device.
- Hold down the “Connect” button located on the base of the device.
- Power on the device while keeping the “Connect” button pressed.
- Wait until all the 3 LED lights are statically ON.
After restart, your Base Station will be successfully reset.
¶ Reset Yealink Handset to Factory Defaults: W52H, W56H, W73H
¶ Step 1: Deregister the handset
- Press the “OK” key.
- Navigate to “Settings” → “Registration” → “De-reg. Handset” Enter PIN “0000” to confirm your deregistration.
- After specifying your handset, press “Select” → When the message “De-register” appears press “Yes” in order to delete registration from DECT station.
¶ Step 2: Reset settings
- Press the “OK” key
- Navigate to “Settings” → “System Settings” → “Handset Rest” → “OK”. When the message “Reset handset to default” appears press “Enter” and insert the PIN “0000”. Press “Yes” to confirm.